39
Before starting
Check warning and indicator lights by turning the starter key
(or the feed switch, see illustration on next page) to check
position.
All the indicator and warning lights, including the central
warning lights, should go on and a buzzer sound when the
starter key (or feed switch) is in check position.
Before starting, the handbrake must be applied and the
gear selector/gear lever must be in neutral position.
EDC internal test
If your bus is fitted with a DH10A engine (with Electronic
Diesel Control), there will be a diagnostic lamp on the dash-
board (see page 86) that goes on constantly when the start-
er key/feed switch is turned to drive position. Provided there
is operating pressure in the brake circuits, it should go out
when the brake pedal is depressed for about 4 seconds.
The EDC internal test must be performed after engine start
and the lamp must go out before cruise control can be used.
Driving
0
Stop position
R
Radio position
1
Drive position
2
Check position
3
Start position
Starting the engine
To Next Page
Loading...
Need help?
General
