ProtoNode FPC-N34 & FPC-N35 User Manual
CHAPTER 2 – BACnet/LonWorks Setup
OMM-0150_B • 5/20/2021 Technical Support • (800) 526-0288 • Mon-Fri, 8 am - 5 pm EST Page 11 of 140
CHAPTER 2. BACNET/LONWORKS SETUP FOR
PROTONODE FPC-N34/FPC-N35
2.1 Record Identification Data
Each ProtoNode has a unique part number located on the side or the back of the unit. This
number should be recorded, as it may be required for technical support. The numbers are as
follows:
Figure 2-1: ProtoNode Part Numbers
• ProtoNode FPC-N34 units have the following 3 ports: RS-485, Ethernet, RS-485
• ProtoNode FPC-N35 units have the following 3 ports: LonWorks, Ethernet, RS-485
2.2 Point Count Capacity and Registers per Device
The total number of Modbus Registers presented by all of the devices attached to the ProtoNode
cannot exceed:
Figure 2-2: Supported Point Count Capacity
AM Managing Boiler/Heater
AM Dependent Boiler/Heater
186 (for 1 up to 16 devices)
Addr 1 to 16 on C-More (SSD address = 247)
* Does not apply to Pneumatic or self-contained controls
Figure 2-3: Modbus Registers per Device