Webasto SVS300 User Manual

SVS-200 Installation, Operation and Maintenance
IMPORTANT INFORMATION – SAVE THESE INSTRUCTIONS
20153-W-03-01 34 Webasto Charging Systems, Inc.
Figure 5- 19 Temperature Readout Selection Screens
5.10.9 Ventilation System
NOTE: This section is only applicable if a ventilation system has been installed and
connected to the charger.
The Ventilation System menus allow the user to set the ventilation system control parameters.
From this menu, the charger may be configured to turn the ventilation system off, to turn it on only
during Equalization, or to turn it on any time the vehicle is being charged.
From the “Ventilation System” screen Press <enter> and then Press <enter> again and the status
(ON or OFF) will flash. Press <up> or <down> to toggle between ON and OFF. Press <enter>
again to accept your selection. Press <clear> to exit.
Figure 5- 20 Ventilation System Setup
Ventilation System
ON When EQing
Ventilation System
ON When Charging
Ventilation System
OFF
Ventilation System
Configuration
CLEAR
ENTER
CLEAR
Charger Configuration
CLEAR
Verify Ventilation
Connection
ENTER
Verify Ventilation
Connection
ENTER
CLEAR
CLEAR
ENTER
Display Temp in:
Celsius
Display Temp in:
Fahrenheit
Temperature Readout
Selection
CLEAR
ENTER
CLEAR
Charger Configuration
CLEAR

Webasto SVS300 Specifications

General

Brand	Webasto
Model	SVS300
Category	Battery Charger
Language	English