上海维宏电子科技股份有限公司
SHANGHAI WEIHONG ELECTRONIC TECHNOLOGY CO., LTD.
4 / 47
The wiring diagram of EX31A1 extended terminal board is as follows:
2. Install Software
This section includes installing the following in order:
1. Camera driver
2. NcStudio V12 CCD control system
During installation, plug-in NcCloud will be installed automatically.
2.1. Install Camera Driver
To install the camera driver, do the following:
1. Optional: If the camera driver has been installed before, uninstall it.
2. Click the camera driver installer and follow the setup wizard.
To Next Page
Loading...
Need help?
General
