上海维宏电子科技股份有限公司
SHANGHAI WEIHONG ELECTRONIC TECHNOLOGY CO., LTD.
43 / 47
After setting, click Start to start machining:
• The system executes length compensation based on Length Wear Increment
of all tool.
• After completing machining once, the values of Finished Times automatically
adds 1 and the system judges whether Length Comp Interval has reached.
– Reach: the system accumulates a Length Wear Increment to the value
of Real-time Length Comp and judges whether the value of Real-time
Length Comp exceeds the value of Max Length Comp.
• Exceed: an alarm The compensation values of automatic layer
compensation exceeds the upper limit. Cannot continue machining!
pops up and machining with current tool stops.
• Not exceeded: machining continues.
– Not reached: the value of Real-time Length Comp keeps unchanged and
machining continues until the value of Finished Times is equal to the
value of Length Comp Interval.
5. Frequently Asked Questions(FAQ)
This section contains answers to common questions in NcStudio V12 CCD Control
System.
For additional questions, contact our technical sales engineers.
5.1. May Errors Exist in the CCD? If Errors Exit, Why It Happens?
Errors may exists in the CCD.
The image algorithm takes pixel as its unit and its accuracy is ±1 pixel.
Example
If the magnification is 200, that is, 200 pixels corresponds to 1 mm, then the error
range in the CCD is ±0.005.
5.2. How Much Error Does the Finished Workpiece Exist in the
CCD?
The error value at the shooting point is ±1 pixel and the error value of the finished
workpeice is determined by specific workpieces.
To Next Page
Loading...
Need help?
General
