WEIHONG Ncstudio V15 User Manual

上海维宏电子科技股份有限公司
SHANGHAI WEIHONG ELECTRONIC TECHNOLOGY CO., LTD.
1 / 116
1 Quick Start
1.1 Overview
This section introduces the hardware and software of the NcStudio V15 laser cutting
control system.
 Hardware
o PM95A motion control card
o Lambda controller
 Non-bus control systems: Lambda 5E controller
 Bus control systems: Lambda NE controller
o EX33A extension terminal board (for follow control)
o EX31A extension terminal board (for extension of terminal board ports)
o SE001 follow-up amplifier
o DB9M/F communication cables * 2
o RF cable * 1
o M16 three-core aviation plug towline cable * 1
o WHB05L wireless handwheel / WHB05N wireless handwheel
For hardware connection diagram, see Hardware Connection Diagram.
 Software
For introduction of the software interface of the NcStudio V15 laser cutting
control system, see introduction of the software interface.
1.2 Hardware Connection Diagram
The connection method varies based on the control system type.
Non-bus control systems
The connection diagram is shown below:

WEIHONG Ncstudio V15 Specifications

General

Brand	WEIHONG
Model	Ncstudio V15
Category	Control Systems
Language	English