WEIHONG Ncstudio V15 User Manual

上海维宏电子科技股份有限公司
SHANGHAI WEIHONG ELECTRONIC TECHNOLOGY CO., LTD.
50 / 116
 Real-time State Check
 Manual Speed
4.3.1 System Setting
Includes the following parameters:
 Axis Direction(Z)
o Description: Specifies the direction for Z-axis mechanical coordinate
increments. Modify the parameter value if you find out during manual
operation that the axis movement direction is opposite to that determined by
the right hand rule.
o Range
 1: positive direction.
 -1: negative direction.
o Value: 1
 Pulse Equivalent
o Description: The distance or angle change for each control pulse.
o Range: 0.000001mm/p–999mm/p
o Value: 0.001mm/p
 Upper Limit of Soft Limit
o Description: Indicates the upper threshold of the soft limits.
o Range: -1000 mm–99999 mm
o Value: 0
 Lower Limit of Soft Limit
o Description: Indicates the lower threshold of the soft limits.
o Range: -99999 mm–0 mm
o Value: -1000
 Screw Pitch
o Description: Indicates the Z-axis screw pitch.
o Range: 0 mm–360 mm
o Value: 10
 Coarse Positioning Direction
o Description: The axis movement direction during coarse positioning phase of
going to the mechanical origin.
o Range
 1: positive.
 -1: negative.
o Value: 1
 Coarse Positioning Speed
o Description: The axis feed rate during coarse positioning phase of going to
the mechanical origin.
o Range: 0.1mm/min–10000mm/min
o Value: 1800
 Retract Distance
o Description: The axis additional moving distance after coarse positioning
phase. A positive value means inward movement and a negative value
means outward movement. 0 means no movement.
o Range: -100mm–1000mm
o Value: 2
4.3.2 Follow Setting
Includes the following parameters:

WEIHONG Ncstudio V15 Specifications

General

Brand	WEIHONG
Model	Ncstudio V15
Category	Control Systems
Language	English