Welch Allyn Spot Vital Signs Service Manual

Service Manual Overview 13
Controls
Figure 1. Spot Vital Signs with SureTemp Plus Thermometer (Version 1)
SpO
2
SS
mm g
a
min
M
P
DIA
mm g
a
MODE
C
Power Button: controls power to the device.
Blood Pressure Start/Stop Button:
initiates a new blood pressure cycle.
Pressing again cancels an active blood
pressure measurement and deflates the cuff.
Mode Button:
• holding for 2 seconds while
the display is active turns off/on
the backlight.
• in Standby Mode, recalls the
last patient information.
• with the temperature probe
removed from the probe holder,
switches the temperature from
Oral to Axillary Mode.
Pressure Hose Connector: port for blood
pressure hose.
Thermometer Eject Button: push to
remove used temperature probe cover.
Printer: press to print the
measurements (Version 1 only).
Next Patient/Clear/Cancel Button:
• active display: clears the display.
• in Standby Mode: recalls the last patient
information. Pressing a second time clears
the screen.
• cancels an active blood pressure
measurement and deflates the cuff.

Welch Allyn Spot Vital Signs Specifications

General

Pulse Rate Measurement	Yes
SpO2 Measurement	Yes
Display	LCD
Power Source	Rechargeable battery or AC power
Temperature Measurement	Yes
Connectivity	Optional with wireless connectivity
Pulse Rate Range	30-220 bpm
NIBP Diastolic Range	20-195 mmHg
SpO2 Range	70-100%
Temperature Range	80 °F to 110 °F (26.7 °C to 43.3 °C)
Battery Life	Approximately 8 hours of continuous operation
Weight Capacity	Not applicable
Height Measurement Range	Not applicable