Loading media in the cover inserter tray
This tray provides an alternate source for cover stocks. Covers may be printed and
supplied by the printer, or they may be manually loaded into this tray. This is especially
useful if you have pre-printed covers that you want to use for the book job.
Caution
Do not use paper that is torn, crimped, stapled, or taped.
Note
• Do not load paper of different sizes.
• A maximum of 200 sheets of cover stock may be loaded in the tray.
• Available paper sizes for the cover inserter tray are:
- Paper width (front-to-back): 10.5-13 in. (B4/257-330.2 mm)
- Paper length (lead-to-trail edge): 14.33 (B4)-19.187 in. (364-488 mm)
1. Open the ream of paper with the seam side facing up.
2. Fan the sheets before loading them into the tray.
3. Load the paper into the inserter tray and adjust the guide to the width of the paper.
Note
Ensure that there are no defects in the paper and that all edges of the paper are
aligned prior to inserting the paper into the Inserter.
a) Load the paper with the outside facing upwards and the top towards the rear of
the tray.
21-13Xerox
®
D95/D110/D125/D136 Copier/Printer
User Guide
Perfect Binder (D110/D125/D136 with integrated controller)
To Next Page
Loading...
Need help?
General