Switching On/Off the Power 29
IE
IE
Switching On/Off the
Power
Switching On the Power
1. Press the power switch to the <|> position.
2. When the power is switched on, the display
reads [Please wait...]. Wait until the message
changes to [Ready to print].
Note
• When the display reads [Please wait...], the printer is
warming up and is not ready to print yet.
• If an error message is displayed, refer to “Error
Messages (in Alphabetical Order)” (P. 59) to remedy the
error.
Switching Off the Power
Important
• Do not switch the power off while the hard disk
(optional) is being accessed.
• Do not switch the power off when the display reads
[Please wait...].
• Do not switch the power off during printing. Doing so
can cause paper jams.
• Switching the power off erases the print data remained
in the printer and the information stored in the printer's
memory.
1. Make sure that the printer is not in operation
by checking the display or indicator lamps.
2. Press the power switch to the <O> position.
About the Circuit Breaker
The printer has a circuit breaker on its rear left
side.
In the event of current leakage, the breaker will
automatically cut off the power circuit to prevent
any current leakages or fire from occurring.
If the circuit breaker trips, check insulation
condition of the printer and then press the
<RESET> button.
If the insulation condition of the printer is not
recovered, the circuit breaker trips again
immediately. In such case, contact our Customer
Support Center or your dealers.
Once a month, switch the printer off and test if the
breaker is functioning normally. Using a failed
breaker puts your printer at risk of electric shock.
If your circuit breaker is not functioning normally,
contact our Customer Support Center or your
dealers.
Refer to
• For information on how to test the circuit breaker, refer
to “ Operational Safety” (P. 11).
RESET button
To Next Page
Loading...
Need help?
General