66 6 Consumable
Handling Consumables
• Do not store consumables upright.
• Do not unpack consumable parts until they are
ready to be used.
• Avoid storing consumable parts in the following
locations:
• in high temperature and humidity
• near heat sources
• in direct sun light
• in dusty places
• When using consumable, make sure to follow
the precautions stated on its packaging.
• We recommend you to keep backup supplies of
consumable.
Replacing the Print Cartridge
When the print cartridge is near or reaches the
end of its life, the following message appears on
the printer’s control panel.
WARNING
• Do not use a vacuum cleaner for cleaning the
spilled toner. Use a broom or a soaked cloth to
clean any spills. Vacuumed toner inside the
cleaner can ignite or explode by an electric
spark of the cleaner and may cause an injury.
• Never throw a print cartridge into fire.
Remaining toner in the cartridge may catch fire
and cause burn injuries. If you have a used
print cartridge no longer needed, contact your
local Fuji Xerox representative for its disposal.
CAUTION
• Keep the print cartridge out of reach of
children. Should toner be swallowed, spit it out,
rinse mouth with water and drink plenty of
water. Consult a physician immediately.
• When replacing the print cartridge, be careful
not to spill the toner. In case of any toner spills,
avoid contact with skin and clothing, as well as
inhalation and contact with eyes and mouth.
• In case of any toner spills onto your skin and
clothing, wash with soap and water.
Should toner particles get into your eyes, flush
with plenty of water for at least 15 minutes until
the irritation is gone. If necessary, seek medical
treatment from a doctor.
If toner particles are inhaled, move to a location
with fresh air and gargle with plenty of water.
Should toner be swallowed, spit it out, rinse
mouth with water and drink plenty of water.
Consult a physician immediately.
Important
• Make sure that the power is on when replacing the print
cartridge. Switching the power off erases the print data
in the printer and information accumulated in the
memory.
• Do not expose the print cartridge to direct sunlight or
strong light.
• Avoid exposure to strong light when installing the print
cartridge and complete the installation in less than one
minute.
• Do not touch the surface of the photoconductor (drum).
Do not place the print cartridge upright or upside down.
Doing so can damage the photoconductor (drum).
• The photoconductor (drum) protection shutter protects
the photoconductor (drum) from exposure to light.
• Do not open the photoconductor (drum) protection
shutter unless necessary.
• We recommend you to use up the print cartridge within
one year after removing it from the packaging.
• Place the print cartridge only on a flat surface..
Message Action
Ready to print
Toner
Ready to print
Replace soon
The print cartridge does not need
to be replaced right away, but
have a new print cartridge ready.
Place the side with the
handles facing up.