Installing the Chinese Font Kit 77
IE
IE
Installing the Chinese Font
Kit
Installing the Chinese font kit (optional) to the
printer will allow you to use Shu Song, Kai Ti, Hei
Ti, and Fang Song fonts in ESC/P-K emulation.
WARNING
• This equipment has been designed to restrict
operator access to safe areas only. Operator
access to hazardous areas is restricted with
covers or guards, which would require a tool to
remove. Never remove these covers or guards.
Important
• Before plugging or unplugging the interface cable
connector, be sure to switch off the printer or unplug the
power cord from the power outlet. Plugging or
unplugging the connector when the printer is on can
cause printer failure.
Note
• For information about the ESC/P-K emulation feature,
refer to the ‘ESC/P Emulation Setting Guide’ on the CD-
ROM supplied with the printer.
• The Chinese font kit cannot be installed simultaneously
with other font kits or the PostScript software kit.
Checking the Package Contents
The packaging box contains the following item. If
you find any item missing, please contact our
Customer Support Center or your dealers.
Important
• Do not touch the terminal area of the ROM.
• Do not bend or damage the ROM.
• Before touching the ROM, touch a metal surface to
discharge any static electricity.
Installation Procedure
The ROM of the Chinese font kit goes into the
controller board right underneath an internal hard
disk (optional). If your printer has an internal hard
disk, remove it to get an access to the ROM slot.
For information on how to uninstall/re-install the
internal hard disk, refer to “ Installing the Internal
Hard Disk” (P. 74)
Follow these steps when installing the Chinese
font ROM to the printer:
1. Switch the power off by pressing the power
switch located on front lower right of the
printer to the <O> position.
Unplug the power cord from the power outlet
and the printer.
2. Remove the two screws that secure the rear
cover to the printer.
•Font ROM
Font ROM
Internal hard disk
To Next Page
Loading...
Need help?
General