Xerox Phaser 4600DN User Manual

General Care and Troubleshooting
Xerox Phaser 4600/4620
User Guide
109
Common PostScript Problems
The following situations are PS language specific and may occur when several printer languages are
used.
The machine does not print
PDF file correctly. Some parts of
graphics, text or illustrations
are missing.
Incompatibility between the
PDF file and the Acrobat
products.
• Printing the PDF file as an image
may enable the file to print. Turn on
Print As Image from the Acrobat
printing options. It will take longer
to print when you print a PDF file as
an image.
The print quality of photos is
not good. Images are not clear.
The resolution of the photo is
very low.
• Reduce the photo size. If you
increase the photo size in the
software application, the resolution
will be reduced.
Before printing, the machine
emits vapor near the output
tray.
Using damp paper can cause
vapor during printing.
• Replace the paper.
The machine does not print
special-sized paper, such as
billing paper.
Paper size and paper size
setting do not match.
• Set the correct paper size in the
Custom Paper Size Settings in the
Paper/Output tab in the Printing
Preferences. (See Paper/Output on
page 31.)
Problem Possible Cause Solution
PostScript file cannot be printed. The PostScript driver may not be
installed correctly.
• Install the PostScript driver.
(Refer to the System
Administrator Guide for
instructions.)
• Print a configuration page
and verify that the PS version
is available for printing.
• If the problem persists,
contact a service
representative.
“Limit Check Error” report prints. The print job was too complex. • You might need to reduce the
complexity of the page or
install more memory. (Refer to
the System Administrator
Guide.)
Condition Possible Cause Suggested Solutions

Xerox Phaser 4600DN Specifications

General

Brand	Xerox
Model	Phaser 4600DN
Category	Printer
Language	English