TCP/IP Protocol Configuration
WorkCentre 7425/7428/7435
System Administrator Guide
43
TCP/IP Protocol Configuration
To view or change the settings of the printer's TCP/IP Protocol Configuration, perform the following
steps:
Accessing TCP/IP Protocol Settings at the Printer
1. Press the Log In/Out button on the control panel.
2. Enter the System Administrator’s Login ID and Passcode if prompted (default admin, 1111), and
press Enter.
3. Press the Machine Status button.
4. Touch the Tools tab.
5. Press Connectivity & Network Setup.
6. Press Protocol Settings.
7. When the Protocol Settings menu displays, note that with the exception of selection one (Ethernet
Rated Speed), the remaining selections are specific to TCP/IP address settings. Choose your setting
by pressing the numbered, horizontal selection line on the touch screen. Note that the current
status of each setting is shown on the applicable line. After pressing a selection line, to access
available settings press the Change Settings button in the lower right corner of the touch screen.
TCP/IP – IP Mode
1. Press the selection line labeled TCP/IP – Mode.
2. Press Change Settings.
3. Select the IP Mode best suited to your network environment. Note that your choices include IPv4
Mode, IPv6 Mode, and Dual Stack. The printer supports IPv6 addressing with an automatically-
built Local Address for broadcasting to routers that can supply the network layer configuration
parameters.
4. For traditional networks (using an address space of xxx.xxx.xxx.xxx), select IPv4 and press Save.
5. Note that the printer may reboot.
IP Address Resolution
1. On the Protocol Settings menu, press the selection line labeled IPv4 (or other mode) Address
Resolution.
2. Press the Change Settings button.
3. On the settings screen, note which one of the buttons is highlighted as the current setting for the
TCP/IP Addressing method. The available settings are DHCP, BOOTP, RARP, DHCP/Autonet, and
STATIC. DHCP/Autonet is the default setting.
4. To change settings, press your selection of choice, then press the Save button.
5. To exit the screen, without making any changes, press the Cancel button.
6. Press Close and, if you made any changes, the system will reboot.
To Next Page
Loading...
Need help?
General
