EtherTalk (AppleTalk) Configuration
WorkCentre 7425/7428/7435
System Administrator Guide
57
EtherTalk (AppleTalk) Configuration
The EtherTalk Protocol enables computer to printer communications over the EtherTalk (AppleTalk)
network.
Changing EtherTalk Settings at the Printer
1. Press the Log In/Out button on the control panel.
2. Enter the System Administrator’s Login ID and Passcode if prompted (default admin, 1111), and
press Enter.
3. Press the Machine Status button.
4. Touch the Tools tab.
5. Press Connectivity & Network Setup.
6. Press Port Settings.
7. Press the EtherTalk selection line on the Port Settings menu.
8. Press the Change Settings button in the lower right corner of the Port Settings menu screen.
9. When the EtherTalk selection menu displays, note that you have only one selection available on a
single, numbered horizontal line, with the current status of this setting shown. The Close button in
the upper right corner of the screen returns you to the Port Settings menu. After pressing the
horizontal line selection, to access available settings press the Change Settings button in the lower
right corner of the touch screen.
Port Status (EtherTalk Enablement)
1. On the EtherTalk selection menu, press the selection line labeled Port Status.
2. Press the Change Settings button.
3. On the Port Status screen, note which of the two buttons is highlighted as the current setting for
EtherTalk Enablement. The available settings are Enabled or Disabled. To print with EtherTalk, this
setting must be Enabled.
4. To change settings, press your setting of choice, then press the Save button.
5. To exit the screen, without making any changes, press the Cancel button.
Exiting the EtherTalk Selection Menu
To exit the EtherTalk selection menu, which returns you to the Port Settings menu, press the Close
button in the upper right corner of the touch screen.
To Next Page
Loading...
Need help?
General
