Xerox WorkCentre 7970 User Manual

Troubleshooting
Restarting the Printer
1. Locate the two power switches.
2. Turn off the switch on the top of the printer. A message appears on the control panel that warns that
the printer is turning off.
3. If the printer turns off, then turn on the switch to restart the printer.
4. If the printer does not turn off after two minutes, then open the front cover and turn off the second
switch.
5. Turn on the bottom switch, then turn on the top switch to restart the printer.
If the problem is not resolved by restarting the printer, see the table in this chapter that best describes the
problem.
Printer Does Not Turn On
Probable Causes Solutions
The power cord is not correctly plugged into
the outlet.
Turn off the printer, and plug the power cord securely into the outlet.
Something is wrong with the outlet connected
to the printer.
• Plug another electrical appliance into the outlet and see if it
operates properly.
• Try a different outlet.
One of the power switches is not turned on.
Turn off both of the power switches. Wait two minutes then turn on
both of the switches.
The printer is connected to an outlet with a
voltage or frequency that does not match the
printer specifications.
Use a power source with the specifications listed in Electrical
Specifications.
CAUTION: Plug the three-wire cord (with grounding prong) directly into a grounded AC outlet only.
Do not use a power strip. If necessary, contact a licensed electrician to install a properly grounded
outlet.
Xerox
®
WorkCentre
®
7970 Multifunction Printer 213
User Guide

Xerox WorkCentre 7970 Specifications

General

Brand	Xerox
Model	WorkCentre 7970
Category	All in One Printer
Language	English