Page 143FT-991 OperaTing Manual
MMB-90
is a mobile bracket used to mount the
FT-991
series in an automotive vehicle.
Installation Procedure
1. Use the enclosed double-sided tape to temporarily
mount the bracket at the installation location and
then fasten the bracket securely with the enclosed
screws so that it does not loosen or detach due to vi-
brations etc.
Mount the unit securely using commercial stays etc.
if the installation location is weak.
If you are mounting the unit using tapping screws,
pay due attention to the strength of the installation
location and check that the bracket does not detach
easily.
2. Use the enclosed knob screws to mount the main
transceiver unit to
MMB-90
.
note:
To install the
MMB-90
, before commencing work, rst
use the following points as a guide to find a suitable
installation location that will allow the transceiver to be
easily operated.
r
Please choose a location that will not affect the op-
eration of the air bag system for cars equipped with
air bags.
r
That will not obstruct the eld of view in front.
r
That will not impede driving.
r
That will not result in danger to the passengers in the
assistant driver’s seat and rear seats etc.
r
That is not exposed to direct sunlight and hot air etc.
r
That is well-ventilated.
Select a at mounting surface. If the mounting surface
is not at, the bracket may be distorted, resulting in the
inability to mount the transceiver.
Be sure to use screws of the specied size to install each
part according to the specified method. Malfunctions
will result if screws of the wrong sizes are used, or if the
unit is mounted wrongly.
Stay (user prepared)
Mounting brAcket MMb-90 inStAllAtion
installation of optional accessories
The viewing angle of the transceiver may be
adjusted by changing the location of the front
mounting screws.
To Next Page
Loading...
Need help?
General
