Yaesu FT-991 User Manual

Page 23
F
T-991
OperaTing Manual
tFt liquid cryStAl diSplAy
about the DisplaY
PLAY
The voice memory/contest memory keyer func-
tions are in use.
PLAY: Playing, REC: Recording
REC
S-Meter
Displays the reception signal strength.
To change the meter peak hold time
1. Press the
MENU(SETUP)
button.
2. Rotate the
MULTI
knob to select “
009 BAR
MTR PEAK HOLD
”.
3. Touch
[
SELECT
]
, then rotate the
MULTI
knob to select the time to hold
(OFF/0.5/1.0/2.0 seconds).
4. Touch
[
ENTER
]
, then
[
BACK
]
or press the
MENU(SETUP)
button.
Meters
The following information can be displayed below the
S-meter.
The displayed information is switched each time [
ME-
TER
] is touched on the panel.
PO Displays transmitter output power.
ALC Displays ALC voltage
SWR Displays antenna matching state
COMP Displays the speech processor compression level
ID
Displays the drain current of the nal stage FET
transistors
VDD
Displays the drain voltage of the nal stage ampli-
er.
The proper voltage is 13.8 V.
Scope/Waterfall
Displays a spectrum or waterfall when the scope func-
tion (see page 40) is in use.
Menu List
Displays the menu item list when making settings in the
menu mode.
Memory List
Displays the data saved in the memory channels.
Function Menu
Displays the function menu from which you can set a
variety of functions.
Touch
[
BACK
]
/
[
FWD
]
to switch the menu screen.
Operation Frequency
Displays the current operation frequency.
Clock
Indicates the current time.
When receiving a GPS signal, the time is set automati-
cally.
GPS Signal Capturing Indicator
Appears when an external GPS device is connected to
the
GPS/CAT
jack on the rear panel and GPS signals
are being acquired.
VFO-B Data/Clarier Operation
Displays operation status of the radio modulation form
and VFO-B frequency, etc.
Displays the offset operation status and the clarier off-
set value, etc.
Main Control Buttons
Frequently used functions can be assigned to these but-
tons.
To change the function assigned
to the main control button
1. Press the
F(M-LIST)
button.
2. Touch
[
BACK
]
/
[
FWD
]
to display screens
“
SWAP F1
” to “
SWAP F4
”.
3. Touch one of the “
SWAP F1
” to “
SWAP
F4
” screens and conrm the function you
want to change ashes.
4. Touch
[
BACK
]
/
[
FWD
]
to display the func-
tion you want to assign, then select and
touch the function.
5. Press the
F(M-LIST)
button.

Yaesu FT-991 Specifications

General

Brand	Yaesu
Model	FT-991
Category	Transceiver
Language	English