Yamaha F6C Service Manual

7-10
Manual starter
0
1
2
3
4
5
6
7
8
9
10
A
16. Align the protrusion g on the starter
plunger b and the mark h on the
manual starter i.
17. Pull the starter handle o several times to
check that the sheave drum turns
smoothly and to check the starter rope e
for slack.
Installing the manual starter
1. Install the manual starter a.
2. Connect the start-in-gear protection
cable b.
Adjusting the start-in-gear
protection cable
Make sure to remove the clip from the
engine shut-off switch before checking
the start-in-gear protection.
1. Move the shift lever to the N position.
2. Loosen the start-in-gear protection cable
locknut a, and then align the protrusion
b on the starter plunger a and the mark
c on the manual starter b.
3. Tighten the start-in-gear protection cable
locknut a to the specified torque.
4. Move the shift lever to the F or R position.
5. Check that the starter handle cannot be
pulled.
Measuring the starter rope
1. Pull the starter handle a to extend the
starter rope b completely, and then
measure the starter rope extended
length a.
o
e
g
h
b
b
i
a
b
Start-in-gear protection cable locknut a:
2 N·m (0.2 kgf·m, 1.5 ft·lb)
Starter rope extended length a:
1430.0–1570.0 mm (56.3–61.8 in)
b
a
a
c
b
a
a
b

Yamaha F6C Specifications

General

Brand	Yamaha
Model	F6C
Category	Outboard Motor
Language	English