PSR-A3000 Owner’s Manual 131
Styles
2
NOTE Intro 4 and Ending 4 can be selected on the display then created as your original Style although they are not available on the panel.
3 Replace the Source Pattern of the specific channel with that of another Style.
3-1 Select the desired channel to be replaced via the [A]–[D] and [F]–[I] buttons.
3-2 Press the same button of the selected channel to call up the Style Selection display.
3-3 Select the desired Style, then press the [EXIT] button to return to the original display.
3-4 Select the Section and Channel of the selected Style via the [2 ]–[5 ] buttons.
3-5 Confirm the sound with the newly assigned Source Pattern by pressing the STYLE CONTROL
[START/STOP] button to play back the Style.
4 As desired, repeat step 3 for another channel.
The created Style will be lost if you change to another Style or turn off the power to the instrument without carrying out the Save operation
(step 7 on page 126).
Playing the Style During Style Assembly
You can play back the Style while you are assembling a Style, and the playback method can be selected. In the
ASSEMBLY page, use the [6 ]/[7 ] (PLAY TYPE) buttons to select the type.
• SOLO: Plays back the selected channel in the ASSEMBLY page. Any channels set to REC in the RECORD
display on the BASIC page are played back simultaneously.
• ON: Plays back the selected channel in the ASSEMBLY page. Any channels set to other than OFF in the
RECORD display on the BASIC page are played back simultaneously.
• OFF: Mutes the selected channel in the ASSEMBLY page.