User Guide for the CP860 HD IP Conference Phone
136
Auto answer is configurable via web user interface at the path Account->Basic.
Note
Auto Redial
For more information, refer to Auto Redial on page 76.
ReCall
For more information, refer to ReCall on page 78.
Call Mute
For more information, refer to Call Mute on page 78.
Call Hold/Resume
You can place a call on hold/resume a held call for PSTN account in the same way as SIP/Cloud
account with the following exceptions: when you place a call on hold, the other party cannot
hear music on hold and the LCD screen of the other party doesn’t indicate that the call is being
held.
For more information, refer to Call Hold/Resume on page 80.
Conference
As one PSTN account can only support one call. To set up a conference, you need to activate a
hook flash. A hook flash is a quick off-hook/on-hook/off-hook cycle (just like picking up a
handset, laying the handset down on the handset cradle, and then picking it up again). When
you activate a hook flash, the message “Flashing” displays on the screen for about one second,
as shown below:
Then the active call will be placed on hold, you are allowed to place a new call and connect three
parties in a conference. You cannot view the last participant in the conference call.
Auto answer is only applicable when there is no other call in progress on the phone.