-11-
3.3.2 Connection of equipment
Connection with the controller
Connect MOTOR1 connector and Filter Wheel 1 with supplied Filter wheel 1 (FW1)
connecting cable.
z If necessary, connect MOTOR2 connector of Filter Wheel 2 with supplied Filter
Wheel 2 (FW2) connecting cable.
z Connect CSU connector of the control unit (CSUX1CU-F1) and the EXT CONTROL
/INTERLOCK connector of CSUX1 with the supplied cable.
Connect the controller interlock key to the EXT INTERFACE1 / I.LOCK .
Connects the RS232C1 connector and PC with supplied RS232C cable.
After checking the power switch is OFF, connect the power cable
Please use the power receptacle which fulfills the following conditions.
* 3 pole electric socket equipped with protective earth terminal.
* Rated supply voltage：100～240VAC
* Power voltage frequency range：90～264VAC
* Rated supply frequency：50～60Hz
* Power frequency latitude：48～63Hz
* Maximum electric power consumption：200VA
Please follow the warnings and cautions below before connecting the power
supply of a controller. If these warning and cautions were not followed, there is a
possibility of causing an electric shock or breakage of apparatus.
WARNING
• Please confirm your power supply is suitable for the rated supply voltage of
this unit before connection.
• Please confirm before connecting the power cord if the power switch of this
unit is off.
• Please ONLY use supplied power code to prevent electrical shock or fire.
• Please be sure to ground the protective earth for electric shock prevention.
• Please always use 3-prong plug with protective earth terminal to avoid risk
of electrification.
• Please do not use the extension code without a protective earth conductor.
Use of such will cancel out protection.
.
To Next Page
Loading...
General