-7-
To reduce the risk of bodily injury of personnel such as electric shock or and/or
damage to the instrument, please comply the following precautions:
WARNING
Power supply
Please make sure the source voltage matches the voltage of the power supply before
turning on the power.
The CSU-X1 is classified as a laser hazard CLASS 3B instrument in accordance with
WHO regulations. Please comply with the remarks on laser safety precautions
described in the next chapter of this manual.
.
CAUTION
The CSU-X1 is used in combination with a microscope, laser system, camera, and
other peripheral instruments. Please read carefully instruction manuals of each
instrument, and follow safety precautions.
Please use input/output terminals of the CSU-X1 within the range of specification as
stated in this manual.
The CSU-X1 is a precision optical instrument. Please do not install the CSU-X1
system under inappropriate circumstances, such as vibrating conditions, dusty place,
very humid and/or high temperature room, drastic change in the room temperature,
corrosive or inflammable atmosphere, etc.
Do not touch inside the CSU-X1. Unauthorized open/touch inside the CSU-X1 may
cause mechanical and optical damages, and may cause serious damages.
Do not touch and soil the surface of the lenses inside the camera port adapter and C
mount port of the CSU-X1 at the time of installation or storing..
In the case of malfunction, please do not open the CSU-X1 but consult Yokogawa
Electric Corporation, or your local representative for proper advice and repair.
.
To Next Page
Loading...
General