Data Capture
121
Scanning with RS6000 Bluetooth Ring Scanner
To read a barcode, a scan-enabled app is required. The device contains the DataWedge app that allows the
user to enable the scanner to decode barcode data and display the barcode content.
To scan with the RS6000:
1. Pair the RS6000 with the device. See Pairing Using Simple Serial Interface on page 128 or Pairing Using
Bluetooth Human Interface Device on page 129 for more information.
2. Ensure that an app is open on the device and a text field is in focus (text cursor in text field).
3. Point the RS6000 at a barcode.
Figure 92 Barcode Scanning with RS6000
4. Press and hold the trigger.
The red laser aiming pattern turns on to assist in aiming. Ensure the barcode is within the area formed by
the cross-hairs in the aiming pattern. The aiming dot increases visibility in bright lighting conditions.
The RS6000 LEDs light green and a beep sounds to indicate the barcode was decoded successfully. When
the RS6000 is in Pick List mode, the RS6000 does not decode the barcode until the center of the crosshair
touches the barcode.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
