Data Capture 5 - 9
• Bluetooth Human Interface Device (HID) Mode.
Pairing Using Near Field Communication
The TC70x/TC75x provides the ability to pair the RS6000 using NFC.
1. Ensure that the RS6000 is in SSI mode. Refer to the RS6000 User Guide for more information.
2. Ensure that NFC is enabled on the TC70x/TC75x.
3. Align the NFC icon on the RS6000 with the NFC antenna on the TC70x/TC75x.
Figure 5-16 Align NFC Antennas
The RS6000 Status LED blinks blue indicating that the RS6000 is attempting to establish connection with the
TC70x/TC75x. When connection is established, the Status LED turns off and the RS6000 emits a single string
of low/high beeps.
A notification appears on the TC70x/TC75x screen and the icon appears in the Status bar.
Pairing in HID Mode Using Near Field Communication
The TC70x/TC75x provides the ability to pair the RS6000 in HID Mode using NFC.
1. Ensure that NFC is enabled on the TC70x/TC75x.
2. Ensure that Bluetooth is enabled on the TC70x/TC75x.
3. Place the RS6000 in Human Interface Device (HID) mode. If the RS6000 is already in HID mode, skip to step
3.
a. Remove the battery from the RS6000.
b. Press and hold the Restore key.
c. Install the battery onto the RS6000.
d. Keep holding the Restore key for about five seconds until a chirp is heard and the Scan LEDs flash green.
NOTE RS6000 only.
NOTE RS6000 only.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
