Copyright 2011 ABB Inc. [July, 2011]
Trademarks and Registrations
Registrations and trademarks used in this document include:
® Delrin Registered trademark of E.I. DuPont de Nemours Company, Incorporated
® Dow Corning Registered trademark of Dow Corning Corporation
® Lexan Registered trademark of General Electric Company, GE Plastics Division
® Monel Registered trademark of International Nickel Company
® Noryl Registered trademark of General Electric Company, GE Plastics Division
® PowerRac Registered trademark of DeZurik, a Unit of General Signal
® Rynite Registered trademark of E.I. DuPont de Nemours Company, Incorporated
® Teflon Registered trademark of E.I. DuPont de Nemours Company, Incorporated
® Valox Registered trademark of General Electric Company, GE Plastics Division
® Viton Registered trademark of E.I. DuPont de Nemours Company, Incorporated
WARNING notices as used in this manual apply to hazards or unsafe practices which could result in personal
injury or death.
CAUTION notices apply to hazards or unsafe practices which could result in property damage.
NOTES highlight procedures and contain information which assist the operator in understanding the informa-
tion contained in this manual.
All software, including design, appearance, algorithms and source codes, is copyrighted by ABB Inc. and is
owned by ABB Inc. or its suppliers.
WARNING
POSSIBLE PROCESS UPSETS. Maintenance must be performed only by qualified personnel and only after
securing equipment controlled by this product. Adjusting or removing this product while it is in the system may
upset the process being controlled. Some process upsets may cause injury or damage.
NOTICE
The information contained in this document is subject to change without notice.
ABB Inc., its affiliates, employees, and agents, and the authors of and contributors to this publication specifi-
cally disclaim all liabilities and warranties, express and implied (including warranties of merchantability and fit-
ness for a particular purpose), for the accuracy, currency, completeness, and/or reliability of the information
contained herein and/or for the fitness for any particular use and/or for the performance of any material and/or
equipment selected in whole or part with the user of/or in reliance upon information contained herein. Selection
of materials and/or equipment is at the sole risk of the user of this publication.
This document contains proprietary information of ABB Inc., and is issued in strict confidence. Its use, or repro-
duction for use, for the reverse engineering, development or manufacture of hardware or software described
herein is prohibited. No part of this document may be photocopied or reproduced without the prior written con-
sent of ABB Inc..
To Next Page
Loading...
Need help?
General
