Password protection
199
1SVC 440 795 M0100
Unlock logic relay
Unlocking the logic relay will deactivate the password. You
can reactivate password protection later via the password
menu or by switching the power supply off and on again.
X Press OK to switch to the main menu.
The PASSWORD… entry will flash.
X Press OK to enter the password entry menu.
The logic relay will display the password entry field.
X Set the password using the cursor buttons:
X Confirm with OK.
If the password is correct, the logic relay will return
automatically to the status display.
The PROGRAM… menu option is now accessible so that you
can edit your circuit diagram.
The system menu is also accessible.
Changing or deleting the password range
X Unlock the logic relay
X Press DEL and ALT to call up the system menu.
X Open the password menu via the menu option SECURITY
r PASSWORD…
The CHANGE PW entry will flash.
The logic relay will only show this menu if a password is
present.
PASSWORD...
STOP RUN å
PASSWORD...
INFO
h
If the logic relay shows PROGRAM… in the main menu
instead of PASSWORD…, this means that there is no
password protection active.
ENTER PASSW
XXXX
PROGRAM...
STOP
PARAMETER
INFO
CHANGE PW
ACTIVATE PW
To Next Page
Loading...
Need help?
General
