Configuring a CL-NET network
97
1SVC 440 795 M1100
Displaying the status display of other stations
On every device with a display, you can display the states of
the inputs and outputs of any other network station.
X Change to the status display and press the ESC button.
The cursor switches to the display of network station NT...
The station number is displayed in front of the inputs and
outputs.
X Change the number of the required station with the Í and
Ú cursor buttons.
X Press the OK button.
X If you want to view the state of the inputs and outputs of
a local expansion, press the OK button.
If you press the ESC button again or the OK button, the
display of the input and output states of the station is
terminated.
1I12..........
I NT1 P-
MO 06:42
1Q1....... RUN
3I12.....7....
I NT3 P-
MO 06:42
3Q1.3..6.. RUN
3R12.....7....
I NT3 DC P-
MO 06:45
3S1.3..6.. RUN
h
The station showing the status on its display cannot read
its own data from the network.
Example: NT3 flashes on station 3. The inputs and outputs
3I.., 3R.., 3Q.. and 3S.. cannot be displayed.
If the NT3 display is not flashing, the inputs and outputs
are shown.
To Next Page
Loading...
Need help?
General
