Commissioning
86
1SVC 440 795 M1100
Wiring
The display system displays a small arrow
l in the circuit
diagram when creating the wiring.
Press ALT to activate the wiring arrow cursor and use the
cursor buttons
Í Ú ú í to move it.
The wiring arrow works between contacts and relays. When
you move the arrow onto a contact or relay coil, it changes
back to the cursor and can be reactivated if required.
X Press ALT to wire the cursor from I 02 through to the
coil field.
The cursor changes into a flashing wiring arrow and
automatically jumps to the next logical wiring position.
X Press the cursor button í. Contact I 02 will be connected
up to the coil field.
h
ALT also has two other functions depending on the cursor
position:
• In the left contact field, you can press ALT to insert a
new empty circuit connection.
• The contact under the cursor can be changed between
a N/O and N/C contact by pressing the ALT button.
ÊÊÊÊÊÊÊ-ÊÊÊÊÊÊÊ-
ÊÊÊÊlÊÊ-ÊÊÊÊÊÊÊ-
ÊÊÊÊÊÊÊ-ÊÊÊÊÊÊÊ-
L: 1 C:1 B:7944
M
l
L
m
h
The display system automatically connects adjacent
contacts up to the coil.
-I 02 l
L: 1 C:3 B:7944
h
You can use DEL to erase a connection at the cursor or
arrow position. Where connections intersect, the vertical
connections are deleted first, then, if you press DEL again,
the horizontal connections are deleted.
To Next Page
Loading...
Need help?
General
