Startup behaviour
359
1SVC 440 795 M1100
The default setting for the display system is for RUN MODE
to be displayed. In other words, the display system starts in
RUN MODE å when the power is switched on.
Behaviour when the circuit diagram is deleted
The setting for the startup behaviour is a display system
device function. When the circuit diagram is deleted this
does not result in the loss of the setting selected.
Behaviour during upload/download to memory
module or PC
When a valid circuit diagram is transferred from the display
system to a memory module or the PC or vice versa, the
setting is still retained.
Possible faults
The display system will not start in RUN mode:
• A program is not available in the display system.
• You have put the display system in STOP mode
(RUN mode menu).
Startup behaviour Menu displayed Status of after startup
The display system has both
operating modes:
Display system starts in STOP mode. RUN MODE STOP mode set
Display system starts in RUN mode. RUN MODE å RUN mode set
h
The display system without a display can only be started in
RUN mode.
To Next Page
Loading...
Need help?
General
