ABB CL Series User Manual

Display system settings
360
1SVC 440 795 M1100
Startup behaviour for memory module
The startup behaviour using a memory module is for
applications where unskilled personnel have to change the
memory module with the logic relay de-energized.
The display system will then only start in RUN mode if a
memory module with a valid program is fitted.
If the program on the memory module is different to the
program in the display system, the program on the module
is loaded first and the device then starts in RUN mode.
X Switch to the System menu.
Activating memory module mode
Requirement: RUN mode is active.
If the display system shows
CARD MODE å in the display,
the display system will only start up in RUN mode at power
on if the memory module fitted contains a valid program.
X Otherwise select CARD MODE and press OK.
The display system will start up with the program on the
memory module.
X Press ESC to return to the status display.
Deactivating memory module mode
X Select CARD MODE å and press OK.
The RUN mode function is deactivated.
The default setting of the display system is for CARD MODE
to be displayed. In other words, the display system without
a memory module starts in RUN mode when the power is
switched on.
h
If the display system is password-protected, the System
menu can only be accessed after the display system has
first been “unlocked” (a section “Unlocking the display
system”, from page 347).
DEBOUNCE å Æ
P BUTTONS
RUN MODE å
CARD MODE å æ
DEBOUNCE å Æ
P BUTTONS
RUN MODE å
CARD MODE æ

ABB CL Series Specifications

General

Brand	ABB
Model	CL Series
Category	Relays
Language	English