Electrical installation
ï¿ General requirements
Electrical installation of the safety system must be performed according to the practices
outlined in chapter Planning the electrical installation in the drive hardware manual.
Chapter Installation checklists (page 41) provides additional advice for the planning.
All wiring must be well protected, routed and clamped where practicable.
When installing cabling it must be assured that there is no pulling or pinching on the cables.
ï¿ Ensuring the EMC compatibility
The system must only be used in the EMC environment it is designed for, or necessary
mitigations must be applied.
34 Planning for installation
To Next Page
Loading...
Need help?
General
