7.6 Standard tools
General
All service (repairs, maintenance, and installation) procedures contains lists of
tools required to perform the specified activity.
All special tools required are listed directly in the procedures while all the tools
that are considered standard are gathered in the standard toolkit and defined in
the following table.
This way, the tools required are the sum of the standard toolkit and any tools listed
in the instruction.
Contents, standard toolkit
ToolQty
Ring-open-end spanner 8-19 mm1
Socket head cap 2.5-17 mm1
Torx socket no: 20-601
Torque wrench 10-100 Nm1
Small screwdriver1
Plastic mallet1
Ratchet head for torque wrench 1/2"1
KM socket (KM10) (6369901-480)1
Socket head cap no: 5, socket 1/2" bit L 20 mm1
Socket head cap no: 6, socket 1/2" bit L 20 mm1
Socket head cap no: 8, socket 1/2" bit L 20 mm1
Small cutting plier1
T-handle with ball head1
Product manual - IRB 2400 229
3HAC022031-001 Revision: P
© Copyright 2004-2018 ABB. All rights reserved.
7 Reference information
7.6 Standard tools
To Next Page
Loading...
Need help?
General