2.4.3 Mechanically restricting the working range of axis 2
General
The range of rotation for axis 2 can be limited mechanically by fitting extra stops
on the lower arm.
Restrictions in working range
The figure below shows the mechanical stops available. The number of items that
are needed for different working ranges are specified in the following table.
xx0200000208
Qty. item 3Qty. item 2Qty. item 1Working range
---+110° / -100°
221+110° / -70°
422+110° / -40°
221+80° / -100°
422+80° / -70°
623+80° / -40°
422+50° / -100°
623+50° / -70°
824+50° / -40°
623+20° / -100°
824+20° / -70°
1025+20° / -40°
Required equipment
NoteArt. no.Equipment
3HAC 2624-1Stop, axis 2
Continues on next page
78 Product manual - IRB 2400
3HAC022031-001 Revision: P
© Copyright 2004-2018 ABB. All rights reserved.
2 Installation and commissioning
2.4.3 Mechanically restricting the working range of axis 2
To Next Page
Loading...
Need help?
General