ABB M2004 User Manual

3 Maintenance
3.7.5. Reading the SIS output logs
3HAC022033-001 Revision: K242
© Copyright 2004-2011 ABB. All rights reserved.
3.7.5. Reading the SIS output logs
General
Whenever a set condition has expired (e.g. max allowed operation time before service), a
message to this effect will be shown in the Operational log.
Access to logs
How to open a log and show its contents is detailed in the User's Guide, chapter Service.
Available messages
The following messages may be shown:
Available in:
SIS message in
the log:
Meaning:
Calendar time Service Message
Service is due!
X calendar days
since last service.
The manually set calendar time limit has expired.
How to set the limit is detailed in section Setting the
SIS parameters on page 240.
Proceed with the required service as detailed in
chapter Repair on page 245 or chapter
Maintenance on page 141 depending on which
type of service.
Calendar time Service Message
X calendar days to
next service.
X number of calendar days remain until the
manually set calendar time limit expires.
How to set the value determining when the
message is to be shown, is detailed in section
Setting the SIS parameters on page 240.
Operation time Service Message
Service is due!
X production hours
since last service.
The manually set operation time limit has expired.
How to set the limit is detailed in section Setting the
SIS parameters on page 240.
Proceed with the required service as detailed in
chapter Repair on page 245 or chapter
Maintenance on page 141 depending on which
type of service.
Operation time Service Message
X production hours
to next service.
X number of operation hours remain until the
manually set operation time limit expires.
How to set the value determining when the
message is to be shown, is detailed in section
Setting the SIS parameters on page 240.
Gearbox time Service Message
Gearbox x requires
service!
The automatically calculated gearbox time limit has
expired.
Proceed with the required service as detailed in
chapter Repair on page 245 or chapter
Maintenance on page 141 depending on which
type of service.
Gearbox time Service Message
X% of the service
interval has expired
for gearbox x!
X percent of gearbox hours remain until the auto-
matically calculated gearbox time limit expires.
How to set the value determining when the
message is to be shown, is detailed in section
Setting the SIS parameters on page 240.
工控帮助教小舒QQ2823408167
长沙工控帮教育科技有限公司

ABB M2004 Specifications

General

Brand	ABB
Model	M2004
Category	Robotics
Language	English