Menu Description
Settings menu Shows the functions that the user has activated.
Add card menu To add and bind RFID cards
2.8.4 Overview of the error codes
If the EVSE detects a problem, the error LED comes on. The mobile app shows the error
code.
Error code Short description Description
0x0004 Overcurrent There is an overload on the EV side.
0x0008 Overvoltage The connection of the phase and neutral wires is
incorrect.
0x0010 Undervoltage The connection of the phase and neutral wires is
incorrect.
0x0100 Internal board to
board communica-
tion error
The internal boards of the EVSE fail to communi-
cate with each other.
0x0102 Residual current er-
ror (DC 6mA)
There is residual current in the charge circuit.
Current leaks into the ground.
0x0104 Residual current er-
ror (AC 30mA)
There is residual current in the charge circuit.
Current leaks into the ground.
0x0106 Residual current
monitor selftest error
The residual current monitoring sensor is defec-
tive.
0x0108 Relay stuck error The relay contact is overheated or has damage.
0x0110 Cable undercapacity On the socket version of the EVSE, the rated
current capacity of the cable is less than the rat-
ed current of the EVSE.
0x0112 Missing earth error The EVSE is not earthed correctly.
0x0114 L/N reverse error Incorrect wiring in the AC input side: The line and
neutral wires are reversed.
0x0116 Overheat The charging current is too high.
0x0118 Missing phase A phase is missing or reversed.
Description
BCM.V3Y01.0-EN | 001 23
To Next Page
Loading...
Need help?
General
