ABB Terra AC Series User Manual

7.3 Connect the AC input cable
7.3.1 Connect the AC input cable (1 phase)
Preliminary requirements
• Torque screw driver • AC input cable (1 phase)
Procedure
1. Loosen the screws (A).
2. Strip the wires. For the specification,
refer to section 11.13.1 .
3. Insert the cable connector into the
terminal block (B).
4. Connect the below wires:
1. Earthing wire (C)
2. Neutral wire (D)
3. AC input wire (E)
Refer to section 11.11 .
5. Tighten the screws (A) to the correct
torque. For the specification, refer to
section 11.16 .
7.3.2 Connect the AC input cable (split phase)(North America)
Preliminary requirements
• Torque screw driver • AC input cable (1 phase)
Procedure
1. Loosen the screws (A).
2. Strip the wires. For the specification,
refer to section 11.13.2 .
3. Insert the cable connector into the
terminal block (B).
4. Connect the below wires:
1. Earthing wire (C)
2. L2 wire for split phase (D)
3. L1 wire for split phase (E)
Refer to section 11.11 .
5. Tighten the screws (A) to the correct
torque. For the specification, refer to
section 11.16 .
B
E
C
D
A
B
E
C
D
A
Electrical installation
32 BCM.V3Y01.0-EN | 001

ABB Terra AC Series Specifications

General

Brand	ABB
Model	Terra AC Series
Category	Battery Charger
Language	English