AERMEC MULTI CONTROL User Manual

15
4598010_00
GB
The MONITOR mode is an additional
screen to the main one. It makes it
possible to keep the working status of
the system chillers under control.
The procedure for accessing this screen
is explained on the next page (Basic
procedures, Enter in MONITOR mode).
1 2 3 4
025
010
050
025
TER
025
010
100
050
PO
+21.0
+20.5
+20.0
+20.3
TUA
+26.0
+25.3
+25.8
+24.9
TIA
1
2
3
4
A
B
• MONITOR mode screen:
Icon Function
A
Indicates the status of the connected chillers (the number below the symbol indicates which chiller the information refers to):
- the icon ( ) indicates that the chiller is on;
- the icon (
OFF
) indicates that the chiller is off;
- the icon (
SB
) indicates that the chiller is standby mode;
- the icon (
) indicates that the chiller pump is on;
- the icon( ) indicates that the chiller is not communicating with the modbus network of the system;
- the icon (
) indicates a failure in the chiller;
- the icon ( ) indicates that the chiller is defrosting.
B
Indicates the percentage of power requested by the thermostat of each chiller (each line is numbered with the chiller index to which it
refers).
C
Indicates the percentage of power supplied by the compressor of each chiller (each line is numbered with the chiller index to which it refers).
D
Indicates the outlet temperature from each chiller (each line is numbered with the chiller index to which it refers).
E
Indicates the inlet temperature from each chiller (each line is numbered with the chiller index to which it refers).
EDC

AERMEC MULTI CONTROL Specifications

General

Brand	AERMEC
Model	MULTI CONTROL
Category	Control Panel
Language	English