AERMEC MULTI CONTROL User Manual

32
GB
4598010_00
Setup menu - UNIT SETUP procedures
The fi rst window of the UNIT SETUP allows the user to set the
working mode at heating (valid if heat pump units or heating
only units are installed in the system); this window displays
the following information:
- Index of the unit to which the setting refers (
1
): indicates
which unit (1, 2, 3 or 4) the work setting refers to.
- Heating setting (
2
): indicates the heating operating set-
point of the units managed by MULTI CONTROL.
From this window it is possible to:
(1) Select a unit to set at heating mode: pressing the keys
D
or
E
decreases or increases the index which indicates which unit
the work setting currently displayed refers to (
1
); remember
that each unit can be set with different work settings
.
(2) Setting at heating mode: pressing the key
C
will allow you
to enter the modifi cation mode and the value will be highlighted;
by pressing the keys
A
or
B
it will be possible to modify the set
value, while pressing the key
C
will confi rm this choice.
(3) Pass on to the next window:
to go to the next window of this menu, press the key
B
.
(4) Exit this window:
press the key
A
to return to the selection of the SETUP menus.
(5) Exit this window:
press the key
F
to return to the selection of the USER menus.
• Setting working mode at HEATING (Password 101 or 303):
A
B
C
ESC
F
Hot setpoint
45.0
o
C
N:1
DE
Hot setpoint
45.0
o
C
N:1
1
2

AERMEC MULTI CONTROL Specifications

General

Brand	AERMEC
Model	MULTI CONTROL
Category	Control Panel
Language	English