35
4598010_00
GB
The fourth window of the UNIT SETUP allows the user to set
the type of unit installed in the system; this window displays
the following information:
- Index of the unit to which the type of unit refers (
1
):
indicates which unit (1, 2, 3 or 4) the data currently displayed
refers to.
- Type of unit (
2
): indicates which type of unit has been
installed (numbered in the system based on the index
1
).
From this window it is possible to:
(1) Select a unit for which to set the type: pressing the keys
D
or
E
decreases or increases the index indicating which unit the
work setting currently displayed refers to (
1
).
(2) Setting type: pressing the key
C
will allow you to enter the
modifi cation mode and the value will be highlighted; by pressing
the keys
A
or
B
it will be possible to modify the parameter value,
while pressing the key
C
will confi rm this choice; the types of units
possible are:
- COOLING ONLY.
- HEATING ONLY.
- HEAT PUMP.
Obviously if the system only has COOLING ONLY units, all the
settings linked to heating and DHW production will be deactivated.
(3) Go back to the previous window:
to go back to the previous window of this menu, press the
key
A
.
(4) Exit this window:
press the key
F
to return to the selection of the USER menus.
• Setting the type of units installed (Password 303):
A
B
C
ESC
F
Type of unit
CHILLER
N:1
DE
Type of unit
CHILLER
N:1
1
2
To Next Page
Loading...
Need help?
General
