AERMEC MULTI CONTROL User Manual

51
4598010_00
GB
The fourth window of the SYSTEM SETUP allows the installer
to set whether the accessory VMF CRP modules are present
or not; there can be a maximum of 3 of these modules, and
each one performs special functions; this window displays
the following information:
- Presence of additional VMF CRP 1 module (
1
): indicates
if a VMF CRP 1 module is installed in the system; index 1,
indicates that this accessory module is used to manage:
- Up to 4 three-way diverter valves to manage hot water
production between the system and DHW.
- Probes for reading inlet and outlet water (SIW and SUW).
- Probes for water reading in DHW storage tank (SAS).
- Probes for external air reading (SAE).
- Presence of additional VMF CRP 2 module (
2
): indicates
if a VMF CRP 2 module is installed in the system; index 2,
indicates that this accessory module is used to manage:
- A supplementary resistance for DHW production (manages
enabling, control and resistance alarm).
- Presence of additional VMF CRP 3 module (
2
): indicates
if a VMF CRP 3 module is installed in the system; index 3,
indicates that this accessory module is used to manage
MULTI CONTROL by remote control; if installed, this module
makes it possible to remotely manage:
- System On-Off (INPUT).
- Alarm reset (INPUT).
- Season changeover (INPUT).
- Alarm summary (OUTPUT).
- Current system status (On/Off) (OUTPUT).
- Current system season (OUTPUT).
- Presence of alarm in one of the units (OUTPUT).
From this window it is possible to:
(1) Set the presence of the accessory modules: pressing
the key
C
will allow you to enter the modifi cation mode
and the fl ag relative to the fi rst VMF CRP module will be
highlighted; by pressing the keys
A
or
B
it will be possible
to modify the status of the fl ag currently displayed, while
pressing the key
C
will confi rm this choice, pressing on to
the next fl ag; the values possible for these fl ags are:
- ( ) module NOT present in the system.
- ( ) module present in the system.
(2) Pass on to the next window:
to go to the next window of this menu, press the key
B
.
(3) Go back to the previous window:
to go back to the previous window of this menu, press the
key
A
.
(4) Exit this window:
press the key
D
to return to the selection of the USER menus.
• Setting the presence of expansion modules (Password 303):
A
B
C
ESC
D
Enabling VMF CRP
VMF CRP 1
VMF CRP 2
VMF CRP 3
Enabling VMF CRP
VMF CRP 1
VMF CRP 2
VMF CRP 3
1
2
3

AERMEC MULTI CONTROL Specifications

General

Brand	AERMEC
Model	MULTI CONTROL
Category	Control Panel
Language	English