A-7
APPENDIX A
Setting Up the HP/Agilent 37900D
From the HP/Agilent 37900D start-up screen highlight MANUAL MODE. Select
until CONFIGURATION is highlighted then hit .
Then from the CONFIGURATION MODE menu, press ’M’ and select the slot to be
modified.
Set up the parameters for Port A as shown below
For Example, to change the Interface Setting;
Press ’I’
A new menu is shown listing the available options. When you have selected the
required option, you are returned to the above menu.
Select Quit (’Q’ from keyboard) twice.
Select Yes (’Y’ from keyboard) to return to start-up screen.
Refer to the HP/Agilent 37900D Monitor Guide for detailed information on using
the HP/Agilent 37900D Signaling Test Set.
t
Retur
➡
PERSONALITY APPLICATIONS MANUAL MODE HELP
RS-449/422, RS-232
SLP Port A Port B
Slot Card +---------------------------+-------------------------+
3 RS449/422,RS232 |RS449 DCE I'FACE HIGH M |RS232 DTE I'FACE HIGH M|
2 Slave Signal | | |
1 |No Card |No Card |
0 |No Card |No Card |
+---------------------------+-------------------------+
------------------------------------------------------------------------------
{{CURRENT SETTING}}
I - Interface >> RS-449/442 >> RS-449/442
S * connection Setup >> MONITOR >> MONITOR
D - DCE/DTE >> DCE >> DTE
C - Clock source >> I/FACE HIGH >> I/FACE HIGH
T - TXD Timing source >> TX CLOCK DTE SOURCED >> TX CLOCK DCE SOURCED
P - mark Polarity >> NORMAL >> NORMAL
O - modify Other port A - Auto-configure other port Q - Quit
Enter menu option:
RS449 DCE I’FACE HIGH M
To Next Page
Loading...
Need help?
General
