1 Publication 1747-UM006B-EN-P - June 2003
Chapter
5
Installation and Wiring
This chapter presents installation and wiring information for the
remote I/O adapter module.
If this product is installed within the European Union or EEA regions
and has the CE mark, the following regulations apply.
European Union Direct
Compliance
EMC Directive
This apparatus is tested to meet Council Directive 89/336
Electromagnetic Compatibility (EMC) using a technical construction
file and the following standards, in whole or in part:
• EN 50081-2 EMC - Generic Emission Standard,
Part 2 - Industrial Environment
• EN 50082-2 EMC - Generic Immunity Standard,
Part 2 - Industrial Environment
The product described in this manual is intended for use in an
industrial environment.
Installing the 1747-ASB
Module
1. Install the module in slot 0 of the remote chassis by aligning the
circuit board with the chassis card guide.
The 1747-ASB module must only be installed in slot 0 (the left
slot) of the remote chassis. Do not install the 1747-ASB module
in the remote expansion chassis.
ATTENTION
!
Disconnect power before attempting to install or
remove the module.
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
To Next Page
Loading...
Need help?
General
