76 Rockwell Automation Publication 1769-UM021G-EN-P - October 2015
Chapter 4 Complete Software Tasks Required at CompactLogix 5370 Controller Installation
The IP address uniquely identifies the controller. The IP address is in the form
xxx.xxx.xxx.xxx where each xxx is a number from 000
…254 with some
exceptions for reserved values. These numbers are examples of reserved values
you cannot use:
• 000.xxx.xxx.xxx
• 127.xxx.xxx.xxx
• 224 to 255.xxx.xxx.xxx
Some other values are reserved based on an application-by-application basis.
You can complete one of these tasks dependent on system conditions:
•Set the IP address for a controller that does not have one assigned.
•Change the IP address for a controller that has an IP address that is
assigned to it.
CompactLogix 5370 controllers have two EtherNet/IP ports to connect to an
EtherNet/IP network. The ports carry the same network traffic as part of the
embedded switch of the controller. However, the controller uses only one IP
address.
To Next Page
Loading...
Need help?
General
