Rockwell Automation Publication 2080-UM005B-EN-E - March 2015 133
Appendix
C
Quickstarts
This chapter covers some common tasks and quickstart instructions that are
aimed to make you familiar with the in Connected Component Workbench. The
following quickstarts are included:
Flash Upgrade Your
Micro800 Firmware
This quick start will show you how to flash update the firmware in a Micro800
controller using ControlFLASH. ControlFLASH is installed or updated with
the latest Micro800 firmware when Connected Components Workbench
software is installed on your computer.
On Micro820 controllers, users can use flash upgrade their controllers through
the Ethernet port, in addition to the USB port of the 2080-REMLCD.
Topic Page
Flash Upgrade Your Micro800 Firmware 133
Establish Communications between RSLinx and a Micro820 Controller
through USB Port on 2080-REMLCD
140
Configure Controller Password 144
Forcing I/Os 148
Using Run Mode Change 150
ATTENTION: All Ethernet settings are reverted to factory default after
a ControlFlash firmware upgrade. For users who need to use the same
static IP address as previously set, for example, use the Memory
Module to store project settings prior to a flash upgrade so that you
can have the option to restore your original Ethernet settings.
To successfully flash update your controller over USB when using the
ControlFLASH software, connect only one controller to your computer,
and do not run ControlFLASH in a virtual machine such as VMware.
To Next Page
Loading...
Need help?
General
