Commissioning
Fig.156: Set enables
◦ If you don’t use the TwinCAT NC.
In this case you must run through the State Machine manually. To do this, follow the instruc-
tions in the chapter Commissioning without the NC [}109].
• The cyclic variable Target torque (Fig. Torque specification) can be used to specify a defined torque.
The value is specified in 1000ths of the rated current and the torque is calculated according to the
following equation, where the rated current refers to the value in the index 0x8011:12 [}168] (rated
current).
EL72x1-0010 127Version: 2.0
To Next Page
Loading...
Need help?
General
