4 BA-102/2EN M54.XXXX
B - Table of contents
4.1 - Pre-setting revolver for drilling depth 19
5 - Working with the assembly machine 20
5.1 - Creating a setup plan 20
5.1.1) Identifying drilling head and ruler 20
5.1.2) Removing setup plan template 20
5.1.3) Creating work piece drawings on the setup plan 20
5.1.4) Drilling head setup for machine 20
5.1.5) Setting drilling depth 21
5.1.6) Setting work top 21
5.1.7) Setting swivel stops (9.1) 21
5.1.8) Storing setup plan 21
6 - Assembly Overview 22
6.1 - Assembly with drilling heads and rulers 22
7 - drilling heads 23
7.1 - General 23
7.1.1) Attaching drilling heads 23
7.1.2) Setting drill bit length 23
7.1.3) Inserting drill bits into the chuck 23
7.1.4) Attaching insertion ram to the swing arm 23
7.2 - drilling heads 24
7.2.1) FH drilling head: MZK.2000 24
7.2.2) MPH drilling and insertion head: MZK.2100 24
7.2.3) MPV drilling and insertion head: MZK.2110 24
7.2.4) SYH drilling head: MZK.2200.01 25
7.2.5) SYV drilling head: MZK.2800 25
7.2.6) BOX drilling head: MZK.2230 25
7.2.7) D drilling head: MZK.2400 25
8 - Rulers 26
8.1 - General 26
8.1.1) Storing rulers 26
8.1.2) Attaching swivel stop (9.1) 26
8.2 - Rulers 26
8.2.1) ST ruler: MZL.2000 standard ruler 26
8.2.2) R ruler: MZL.2010 Reversible ruler 26
8.2.3) LD ruler: MZL.2080 line drilling ruler 27
8.2.4) E ruler: MZL.2090 extension ruler 27
8.2.5) Ruler supports: MZV.2000 for extension ruler 27
9 - Maintenance and service 28
9.1 - Maintenance 28
9.1.1) Maintenance 28
9.1.2) Replacing the operational status indicator 28
9.1.3) Replacing a damaged gearbox coupling 28
10 - Troubleshooting 29
10.1 - Error during drilling 29
10.2 - Fitting insertion error 32
10.3 - Function errors 32
11 - Appendix 34
11.1 – User-supplied work top 34
12 - Diagrams 35
12.1 - Electrical diagram1x 230 V 50 Hz 35
12.2 - Electrical diagram 3x 220 V 60 Hz 35
12.3 - Electrical diagram 3x 230 V 50 Hz 36
12.4 - Electrical diagram 3x 400 V 50 Hz 36
12.5 - Pneumatic diagram 37
Notes 38
To Next Page
Loading...
Need help?
General
