BLUM MINIPRESS PRO User Manual

6 BA-102/2EN M54.XXXX
• Thismachinecomplieswithcurrentsafetystandards.However,risksremainfor
• theoperatorandsecondpersonsduetothestrokemovementofthedrillingunitandespeciallyincasesafetydevicesareremoved
or control elements should fail.
• Otherremainingrisksareindicatedbythesafetydecalsandinthefollowingsafetyrules.Itisthereforeabsolutelynecessarytofol-
low all safety instructions carefully.
D.1- Remaining risks according to ISO EN 12100-2
D - Safety information
D.2 - Safety decals
D.3 - Intended use
• Thedesignatedpurposeoftheassemblymachineisthedrillingandinsertionoffurniturefittingsintoworkpiecesmadeofwood,
particle board or plastic coated wood. The assembly machine should only be used in manufacturing. The assembly machine is only
intended for stationary operation. The manufacturer does not assume liability for uses not described in the instruction manual.
• Theintendedpurposeofthelasermarkinglineismeasurementandpositiondeterminationontheworkpiece.
Only wood or particle board should be used as the work piece since they are non-reflective. Coated and/or reflective work pieces
may not be used.
• Themachineisnotexplosion-proof.Itshouldnotbesetupnearapaintfinishingsystem
Completely read the operating instructions and the safety information before operating the assembly machine
Wear proper eye and face protection when operating this machine
Only one person at a time must operate the machine.
The work area is located in front of the machine.
Electrical connections and maintenance should only be performed by a qualified electrician.
Disconnect electrical and pneumatic connections before making any repairs (plug / rapid hose coupling).
Keep hands away from the drill or swing arm during the drilling or insertion process.
Do not remove safety devices - danger of injury.
Keep hands away from the danger zone. - danger of being crushed
Wear proper ear protection when operating this machine
Class 2M laser - Never look directly into the laser beam. The laser can cause eye damage.

BLUM MINIPRESS PRO Specifications

General

Brand	BLUM
Model	MINIPRESS PRO
Category	Power Tool
Language	English