19
F
Drilling of hinge pattern
35
F
3
8
F
2
F
1
F
2
F
1
F
2
F
2
F
3
8
F5
F7
F6
3. Select drill pattern
• Pull out fixing pin (F5) on drill
head.
• At the same time, move lever (F6)
to symbol for hinge drilling pattern
(F7).
• Make sure fixing pin (F5) snaps
back to lock gearbox position!
4. Install drill bits
• Before installing drill bits, always
disconnect the machine from it’s
electrical source (unplugged).
• main switch (E1) to set up position.
• Push drill bits all the way in to the
chucks. Tighten set screw on flat
spot of drill-bit shank only.
• Use a hex wrench to tighten the
fastening screws. (4 mm)
• Insert cover cap (F3) into the empty
chucks. This keeps set screws in
place, and prevents wood chips from
accumulating in chucks.
%$0,1,35(66)$,G1US $0
To Next Page
Loading...
Need help?
General
