BLUM MINIPRESS User Manual

27
F
Hinge insertion

Auto off
!
R
R
E1
E2
E3
F9
D7
A
F8
F21
F8
F22
18. Drilling
WARNING!
To avoid serious injury, all
items must be removed
from the working area of the
machine, except the
workpiece! Keep your hands
out of working area (A).
• Swivel out the drilling depth gauge (F9).
• Set the main switch (E1) to drill /
press position.
• Set the hold-down switch (E3)
to pos. off
• Be sure to swivel the swing arm (F8)
upward.
• When drilling, keep one hand against
the outside edge of the door nearest
to you (outside of zone A) and push it
against the swivel stops - D7.
• Press the drill / press stoke button
(E2) until the drilling depth is reached.
• Release the drill / press stroke button
19. Check alignment of swing arm
(F8)
• Move Swing Arm (F8) down to stop
• Make sure the hinge is aligned with
the drilled hole.
• There are two possibilities which
could cause misalignment:
a) Swing arm (F8) is not vertical:
adjust screw (F21).
b) Insertionram is off center:
adjust ram adjustment screws
(F22).
Note:
If you press the drill / press
stroke button (E2) by only a
few mm (1/16"), the drilling
and pressing unit will move
down at a slower speed.
%$0,1,35(66)$,G1US $0

BLUM MINIPRESS Specifications

General

Brand	BLUM
Model	MINIPRESS
Category	Power Tool
Language	English